For mount the own chip we must have :

 

- A Wii COnsole with Chipset D2C

- a Chip Argonc that we can buy on own sponsor Hardstore

- the soldering at 11W whith Tip thin at 0.5 mm max 1 mm

- the wire pond at 0.6mm o lower but is reccomended the pasta pong

- the autoEject AWG 30

- the Pasta firm

- Braid absorption pond

- tape

- cable USB type A/MINI B for programming the chip

 

If we want working good we must have :

 

- A magnifying glass

- good manuality

- Steady hand

 

ORIGINAL MOUNTING POINTS ON CHIPSET D2C

 

The scheme reported on this photo refer to new version that support the Import game , for using we must have the programming chip with version 1.3 o top of the FW for Wiiktus

 

 

How we can see one of the point must be connect in base of the region of the console :

 

- For the Wii Pal connect the point "D4"

- For the Wii USA connect the point "D3"
- For the point Wii JAP connect the point "D5"

 

For the first position the chip how in this photo :

 

 

Connect all the point in bae of the own scheme , connect the power on and the cable flat need for update che chip , use the little wire and little power. If is possibile the mass and powering must be double:

 

 

The final result will be this : ( how we can see i have used the little variability for connect the wire ):

 

 

Using the tape on the chip so we can do courts. Fix the wire with tape so they cant muove.

 

MOUNTING USING THE ALTERNATIVE POINTS

 

For start with mounting using the alternative point we must remove the PCB of the reader , for do this remove the screws 1 and Undocking the flat present on 2 . Be careful with the lens of the flat is delicat :

 

 

Afer Upside down we have PCB on your hands , the important zone is reported on this photo :

 

 

Start with mount the wire follow this scheme . I would remind you that the alternative point are used for not mount directly the chipset D2C of the console, the six wire Remaining must be connect on the top parts of the PCB :

 

 

Now position the flat , i have Fact slip between the protection carter and the MemoryCard Port

 

 

With this method the flat is easy to reach and is not visible because is protect with the side door of the console :

 

 

Fix the flat with the tapce:

 

 

Close the console how we can see on this photo :

 

 

 

The mounting of the chip is finish now we can updated it , i would remember you that in this moment the chip dont work because it must be programmed

 

Programming Infectus mode WiiKtus --->