TUTORIAL FOR ISTALLATION OF THE CHIP INFECTUS ON THE BENQ READER

Then you will be shown the way to the first reading FW inside of your reader Benq and then one for re-typing.

First you must:

- The download and installed Infectus Programmer who are here: Click

- Downloaded and installed the drivers that serve to recognize the Infectus System: Click

Turn your console Infectus connect to the USB port and start the program (if we are being asked to update the chip loader accepted):

 

Once finished Update loader inside the chip go on "Actel Firmware" and select "Macronix Emulator":

 

 

Always on "Actel Firmware" select "UPDATE" and await the end of the programming:

 

 

Once programmed our infectus, we go on "Flash Command" and select "Xbox Flash":

 

 

Also from the same menu we run the command "READ":

 

 

We decide where to save the backup of our original FW::

 

 

And expect the reading program ends.

 

We now turn to 'insertion of FW hack on our reader, to make things we need:

- Package available regarding FTP Benq iXtreme of Xbins

We back up our original Fw previously extracted and the place within the folder BENQ 1.X and iXtreme Launch program "Make iXtreme Firmware":

The process will be fully automated and eventually would generate the new FW Hack:

Take the newly created FW and proceed with the upgrade of the chip

First bootstrap your infectus programmer and go on "Flash Command" and select "Chip Flash \ Write":

 

 

We select our newly created Hack FW:

 

 

 

And we start writing:

 

 

 

If you have a chip Infectus 2 can decide to flashing the second banck available in order to have the console Fw 3, To do this you must not do nothing but follow the same procedure done before, only that when you are asked to choose bench, Select the bank 1:

 

Done, our reader Benq he said that the Fw iXtreme dedicated, there remains more than reassemble everything on the console and Test for proper operation.

I briefly illustrate the operation of the two seats on the board Switch external dell'Infectus 2:
The switch selects the number 1 banck to start the chip (starting with the first or second Fw Hack)
The switches select the number 2 or less enabling the chip to decide whether to do it or leave it remain perpetually Off despite the kind of start that you do.

For the record the operating table is so divided:

- Switch to OFF 1 Fw start on the banck 0
- Switch1 ON start on the banck Fw 1

- Switch 2 OFF Infectus operation and start with regular chips or disabled with slight pressure was Ignition
And chip enabled pressure with two seconds of the power button
- Switch 2 ON Infectus DISABLED COMPLETELY
 

I remind you that all changes were to be made of Switch ALWAYS to Console Off
 

Back to Start

 

For technical support click here: Forum Xbox-Inf

 

THANKS: Hardstore, Oscar Dalvit, Splinter, the Hardstore Team and the Origa Team

 

Tutorial Written by Titty, translated by ShadowX24 for the Xbox-Inf Forum