TUTORIAL FOR INSTALLING AND PROGRAMMING THE INFECTUS 2 WITH WASABUS

For programming the own chip we must have :

- The final versio of the Firmware for Wasabus that we can download on the official Infectus Webiste: CLICK

- The final version of the Infectus Programmer that we can download on the official Infectus Webiste: CLICK

Connect the Infectus at the USB Port and start the Program ( If must required to update the loader of the chip allow).

After we have finish the update of the loader close the programmer , disconnect and reconnect the USB on the chip , setting the Switch on OFF and reset the programmer , go to TOOLS and select "OPEN INFECTUS":

After the windows is showed go to "LOAD DAT":

Select the file "wasabus.dat" that we can download on the INFECTUS WEBISTE:

After the firmware is loaded click on the PROGRAM ( If there is error type : "The IDCODE of the target device does not match the STAPL file" power on the console and retry):

Waiting the finish of the programmation:

"

After the programmation is finish close the programmer , disconnect and reconnect the USB on the Chip and reset the programmer , go to FLASH command/Write:

Select the file "wasabi" that we can download on Infecus official webiste:

Select the "banck0" and start the programming:

At the end of programming try the console

Go to Home

For technical support click here: Forum Wii-Inf

THANKS: Hardstore, Oscar Dalvit, Splinter, the Hardstore Team and the Origa Team

Tutorial Written by Titty, translated by ShadowX24 for the Xbox-Inf Forum