TUTORIAL FOR ISTALLING AND  PROGRAMMING THE CHIP ARGON

For programming the own chip argon we must have :

- the programmer Infectus that we can buy on own sponsor Hardstore: CLICK
- the final versione of the firmware for chip argon that we can download on download section of the infectuswebsite: CLICK
- the final versione of the infectus programmer that we can download from the infectus website: CLICK

Connect the infectus at the flat of the own chip and inseret the USB on own PC and start the infectus programer and go to "Tools\Open Infectus":

Click on the LOADER DAT buttone and select the Firmware for own chip:

From 1.7 onwards FW has been a subsequent division between models Argon, this should be done according to the type of Actel Mounted at the Argon chip is equipped with the type A3P125 e A3P250. It follows that need a special Fw according to Actel chip mounted.

To learn what your mount Argon just to be careful to IDCODE:

- If the reports the acronym IDCODE 2a121cf mean that a mounted A3P125, then you have to take that says FW 125

- If the reports the acronym IDCODE 2a141cf mean that a mounted A3P250, then you have to take that says FW 250

After loading the Firmware click on PROGRAM

- if the chip is not installed the console start automatically the programmation
- if we have already installed the chip on console and there is a error type : The IDCODE of the target device does not match the STAPL file, power on the console and retry :

And attending that the program finish :

At the End of the programmation we can remove Infectus and try the own console

Back to Home

 

For technical support click here: Forum Wii-Inf

 

THANKS: Hardstore, Oscar Dalvit, Splinter, the Hardstore Team and the Origa Team

 

Tutorial Written by Titty, translated by ShadowX24 for the Xbox-Inf Forum